Swim Spas represent special difficulties when it concerns covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting occasion in life. You’re looking forward to the workout you’ll obtain from using it. Possibly you’re a little relieved to have actually lastly made a selection from the different designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that gets back with your new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence due to the fact that as quickly as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really little as they rise from the water surface. They make their method into the little cracks and crevices in the foam.
Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It occurs slowly and on a Swim Spa Cover which is made of individual sections, at differing speeds. So ultimately you’ll notice a couple of of the areas are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately end up in some landfill, they developed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the cover for it.
If you’re not ready to buy today, bookmark this site so you can discover it again when you’re prepared!