The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot harder.
Getting a brand-new swim spa is an exciting occasion in life. You’re eagerly anticipating the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have actually lastly selected from the various models you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that comes home with your new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are really little as they increase from the water surface area. They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So eventually you’ll observe one or two of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much aid since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will ultimately wind up in some landfill, they designed one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to order today, bookmark this website so you can discover it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *