Swim Spas represent unique difficulties when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting occasion in life. You’re anticipating the workout you’ll receive from using it. Maybe you’re a little relieved to have actually finally made a selection from the various designs you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Typically, the cover that comes home with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence due to the fact that as soon as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very small as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It occurs gradually and on a Swim Spa Cover which is made from individual sections, at differing speeds. So eventually you’ll notice a couple of of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance since you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using several foam panels to build Swim Spa Covers that will ultimately end up in some landfill, they developed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the cover for it.
If you’re not prepared to order today, bookmark this site so you can discover it once again when you’re all set!