Swim Spas represent special difficulties when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot harder.
Getting a new swim spa is an amazing occasion in life. You’re looking forward to the exercise you’ll receive from using it. Maybe you’re a little relieved to have actually finally selected from the various designs you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets home with your new purchase will be a 4 section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence because as soon as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very small as they rise from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place gradually and on a Swim Spa Cover which is made from specific sections, at differing speeds. So eventually you’ll observe a couple of of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much aid since you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different style for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately wind up in some land fill, they created one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to order today, bookmark this website so you can find it again when you’re all set!
