Swim Spas represent special obstacles when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an exciting occasion in life. You’re eagerly anticipating the exercise you’ll get from using it. Maybe you’re a little relieved to have actually finally selected from the various models you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets home with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely small as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place slowly and on a Swim Spa Cover which is made from private areas, at differing speeds. So eventually you’ll discover one or two of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using numerous foam panels to develop Swim Spa Covers that will eventually end up in some landfill, they developed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this website so you can discover it again when you’re all set!
