Getting The Best Swim Spa Cover

Swim Spas represent special difficulties when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot harder.
Getting a new swim spa is an exciting occasion in life. You’re looking forward to the exercise you’ll get from using it. Perhaps you’re a little relieved to have actually finally made a selection from the various designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Generally, the cover that gets back with your new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very little as they rise from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made of individual areas, at varying speeds. So eventually you’ll notice a couple of of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance due to the fact that you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately wind up in some garbage dump, they developed one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the cover for it.
If you’re not all set to order today, bookmark this site so you can discover it again when you’re all set!