Swim Spas represent special difficulties when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an exciting occasion in life. You’re looking forward to the workout you’ll obtain from using it. Possibly you’re a little relieved to have actually lastly selected from the various designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a four area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence due to the fact that as soon as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really little as they increase from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs gradually and on a Swim Spa Cover which is made from specific sections, at differing speeds. So ultimately you’ll notice a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still need to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually end up in some landfill, they developed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this website so you can discover it again when you’re all set!