Getting The Best Swim Spa Cover

Swim Spas represent special obstacles when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a new swim spa is an exciting event in life. You’re looking forward to the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have actually finally selected from the different designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence due to the fact that as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very small as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made from private areas, at differing speeds. So ultimately you’ll notice one or two of the areas are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much help due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will eventually end up in some landfill, they developed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the cover for it.
If you’re not ready to purchase today, bookmark this site so you can discover it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *