Getting The Best Swim Spa Cover

Swim Spas represent special challenges when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot harder.
Getting a new swim spa is an exciting event in life. You’re anticipating the workout you’ll get from using it. Maybe you’re a little relieved to have finally selected from the different models you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that gets back with your brand-new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence since as soon as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very little as they rise from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made of private sections, at differing speeds. So ultimately you’ll see a couple of of the areas are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much help because you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different style for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually end up in some land fill, they developed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this website so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *