The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot more difficult.
Getting a new swim spa is an exciting occasion in life. You’re eagerly anticipating the exercise you’ll receive from using it. Maybe you’re a little relieved to have finally made a selection from the different designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets back with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence due to the fact that as quickly as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are really little as they increase from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made of individual sections, at varying speeds. So ultimately you’ll see one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a various design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will ultimately wind up in some landfill, they developed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to order today, bookmark this website so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *