The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it pertains to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing event in life. You’re looking forward to the workout you’ll receive from using it. Possibly you’re a little relieved to have actually finally selected from the various designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Generally, the cover that comes home with your brand-new purchase will be a 4 area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are really small as they rise from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made from specific sections, at varying speeds. So ultimately you’ll observe one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will eventually end up in some land fill, they developed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to buy today, bookmark this site so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *