The Challenges to Swim Spa Covers

Swim Spas represent unique challenges when it concerns covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a new swim spa is an exciting occasion in life. You’re looking forward to the workout you’ll get from using it. Maybe you’re a little relieved to have lastly selected from the various models you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Typically, the cover that gets home with your brand-new purchase will be a 4 section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are very small as they rise from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made from individual sections, at differing speeds. So eventually you’ll discover one or two of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance since you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a new design for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will ultimately wind up in some garbage dump, they designed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to buy today, bookmark this website so you can discover it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *