The Challenges to Swim Spa Covers

Swim Spas represent unique challenges when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting event in life. You’re eagerly anticipating the exercise you’ll receive from using it. Perhaps you’re a little relieved to have lastly made a selection from the different designs you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a four area stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they rise from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place slowly and on a Swim Spa Cover which is made from individual areas, at differing speeds. So eventually you’ll see one or two of the areas are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much help since you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a new design for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately end up in some landfill, they developed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this site so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *